| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Emission Control | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000030YE006X |
| Title: 3UR-FE EMISSION CONTROL: AIR PUMP: REMOVAL (2008 Sequoia) | ||
REMOVAL
1. SEPARATE FRONT FENDER LINER RH
|
(a) Remove the 8 clips, separate the fender liner. |
2. SEPARATE FRONT FENDER APRON SEAL RH
|
(a) Using a clip remover, separate the 2 clips and fold back the fender apron seal. |
3. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE
|
(a) Engine Room Side: (1) Disconnect the 2 clamps. (2) Disconnect the No. 2 air injection system hose. (3) Using a clip remover, remove the clamp from the body panel. |
(b) Front Fender RH Inside:
(1) Disconnect the clamp.
(2) Disconnect the No. 2 air injection system hose from the air pump.
4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE
|
(a) Engine Room Side: (1) Disconnect the clamp and No. 3 air injection system hose. (2) Using a clip remover, remove the clamp from the body panel. |
(b) Front Fender RH Inside:
(1) Disconnect the clamp and No. 3 air injection system hose from the air pump.
(2) Using a clip remover, remove the clamp from the body panel.
5. REMOVE AIR PUMP ASSEMBLY WITH BRACKET
|
(a) Disconnect the 2 air pump connectors and detach the 3 wire harness claws. |
|
(b) Remove the 2 bolts, 2 nuts and air pump. |
6. REMOVE AIR PUMP INLET
|
(a) Remove the 2 bolts and air pump inlet. |
7. DISCONNECT NO. 1 AIR INJECTION SYSTEM HOSE
(a) Disconnect the 2 No. 1 air injection system hose.
8. REMOVE AIR PUMP ASSEMBLY
|
(a) Using a clip remover, detach the 2 clamps and remove the air pump from the bracket. |
(b) Disconnect the 6 air pump insulators.
|
|